![]() ![]() On the main menu on top it says "LSI Corp Config Utility For Dell SAS Ctlr v7.11.10.00 (2011.06.02)"ĭigging into the menu, I found a bit more details.Īny help appreciated, I would want to have my other card flashed to the same or similar firmware so I can check on the drives during boot time. I tried contacting the guy to get details on what he flashed it to and I'm waiting on a reply, but I wanted to ask the community if they knew what he flashed it as? It's kinda nice, shows information on the drives, which slot it's in, ability to turn off/on smart data, etc. With that, I pop out the card out and add the other card already flashed into IT mode to check it and unlike the other card, it has a boot menu so I went in to check it out. I believe I did it properly as I can see the bare drives CLI with a blkid command. It allows you Only the PERC H310 controller allows configuration of disk drives as Non-RAID. When I had it with the stock dell firmware, there was a bootmenu for the card, but after flashing it to IT mode there's no boot menu. Download the latest BIOS, firmware, or UEFI update v1. I used this tutorial to flash the card with the default firmware and everything went pretty smooth other than a few UEFI issues. I bought two Dell H310 cards, one was stock with Dell's default firmware on it and the other one, the guy said he had already flashed it to IT mode. My apologies if this is in the wrong area to ask. Hopefully flashing cards falls under general unRAID support.
0 Comments
Leave a Reply. |